Discharge will take what it needs from the source, and if any charge is left above the load, it will charge the bank. The discharge settings are for discharging your battery to the grid For normal use (discharge to load) you leave them all at 0:00. Then the two batteries are in parallel to the positive and negative bus Everything seems great except this They aren't discharging equally during low draw loads
A 5 amp load, for example is pulling 4.5 amps from one battery and a half amp from the other Larger draws (100 amps for example) pull equally from the batteries. I just got to try out my new setup in my rv I’m running 2 litime 280 ah batteries in parallel The bms on both were on standby and fully charged As i started using power (12 volt fridge and furnace), only one battery started discharging
Hi all, i have a solax x1 hybrid inverter, 2 x triple 45ah batteries and 5kw of panels We have no feed in tariff here so i do not want to send anything out to the grid I read some threads regarding charging and discharging the battery at the same time but i am still a bit confused In a super simple setup with 100w solar panel, pwm controller, battery and a load (i.e Led lights), can the solar panel charge at the same time when the led lights are connected. Greetings, i am a total newbie regarding lithium batteries
I replaced the lead acid batteries on my travel trailer with 2 litime 100 ah group 24 batteries The batteries are wired as shown Only the drivers side battery is discharging any power When i swap the 2 batteries i get the same. You can't charge a battery and discharge it at the same time Current can only go one direction with a battery
Can the system charge the battery while powering loads Youbetcha, but your loads have to be lower than your pv input. Hey all, i've been facing an issue with my growatt inverter recently and was hoping to get some insights from the community
OPEN
