Cutting off the right side slide release from the ambi part eliminates that friction, which is most prevalent at the wall of the trigger pull You can actually see the right side of the frame push out a little as the trigger pull completes and the trigger bar rubs against the ambi release. The ambi mag release works just like the p320 one when taking in apart A reviewer i saw said the p22 uses the same mag release as the p320 but that is not totally correct. My recent experience with a wilson was disappointing One cracked before i completed installation, the replacement was so spongy that pushing the right hand side wouldn't completely disengage the left side
These weren't the shielded ones mind you, but these ambi ones were just mim'd. Egw's ambi safety is one of the ones where the right safety is retained by a custom hammer pin You cannot remove the right safety without first removing the left Chris, try wiggling the safety in and out perpendicular to the frame The safety wants to come straight out If you are just pulling outward on the paddle, you'll have a.
Please feel free to dumb this do. Some of the criticisms of the shadow 2 compact was lack of firing pin block and not being a decocker So it was almost perfect And is what makes it a shadow So now with whatever wisdom this is, they added the firing pin block and ambi decock levers They also changed the optic system which looks like the nocturne setup
Direct mount for holosun k, vortex ccw and 320 sights I picked a new to me prodigy today Excellent condition as the seller stated Anyway, i run my guns from the port side Flipping the ambi safety to off will pinch the palm of my left hand I don’t have this issue with my 1911’s but the 1911’s don’t have the fat grip of the prodigy
They run through my glocks fine but there isn’t quite enough crimp on them to make the prodigy happy There is an oocassional ftf with these loads Everything else runs like a champ The chamber is a little tighter than my glocks Wilson high wide ambi thumb safety
OPEN
